Physical Values
WARNING: This page is about a different variant/trim than selected.
| Terminal No. (Wire color) |
Description | Condition | Value (Approx.) | |||
|---|---|---|---|---|---|---|
| + | - | Signal name | Input/Output | |||
| 1 (LG) |
Ground | AWD solenoid power supply | Output | Engine speed: At idle | 0 V | |
| Engine speed: 3, 000 RPM or more constant | 2.5 V * | |||||
| 2 (V) |
Ground | AWD solenoid ground | - | Always | 0 V | |
| 7 (W) |
Ground | Ignition switch | Input | Ignition switch: ON | Battery voltage | |
| Ignition switch: OFF | 0 V | |||||
| 8 (L) |
- | CAN-H | Input/Output | - | - | |
| 9 (SB) |
Ground | Power supply (AWD solenoid) | Input | Always | Battery voltage | |
| 10 (GR) |
Ground | Ground | - | Always | 0 V | |
| 11 (GR) |
Ground | Ground | - | Always | 0 V | |
| 15 (Y) |
Ground | Power supply (AWD control unit) | Input | Always | Battery voltage | |
| 16 (P) |
- | CAN-L | Input/Output | - | - | |
*: The values are changed by throttle opening and engine speed.
CAUTION:
When using circuit tester to measure voltage for inspection, be sure not to extend forcibly any connector terminals.