LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 97 (Driver Assistance System (Symptom Diagnosis & Removal And Installation) (DCA) (Except Hybrid)) >> Symptom Diagnosis >> DCA System Settings Cannot Be Turned On/Off In Vehicle Information Display >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. CHECK DCA SYSTEM SETTING

    1. Start the engine.
    2. Check that the DCA system setting can be turned ON/OFF in the combination meter information display using the steering switch.

    Is the inspection result normal?

    YES 

    Inspection End.

    NO 

    GO TO STEP 2. 

  2. CHECK STEERING SWITCH CIRCUIT

    Check the steering switch. Refer to DIAGNOSIS PROCEDURE .

    Is the inspection result normal?

    YES 

    GO TO STEP 3. 

    NO 

    Repair or replace harness or connector.

  3. CHECK STEERING SWITCH RESISTANCE

    Check the steering switch resistance. Refer to COMPONENT INSPECTION .

    Is the inspection result normal?

    YES 

    Replace combination meter. Refer to REMOVAL AND INSTALLATION .

    NO 

    Replace steering switch. Refer to REMOVAL AND INSTALLATION .

scientia non olet · About LEMON Manuals