Diagnosis Procedure
WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
Regarding Wiring Diagram information, refer to WIRING DIAGRAM .
- CHECK SLIDING MOTOR LH POWER SUPPLY
- Turn the ignition switch to ACC.
- Perform "ACTIVE TEST" (+)"SEAT SLIDE") with CONSULT.
- Check voltage between driver seat control unit harness connector and ground.
(+) (-) Condition Voltage (V)
(Approx.)Driver seat control unit Connector Terminal B210 36 Ground SEAT SLIDE OFF 0 FR (forward) 0 RR (backward) Battery voltage 44 OFF 0 FR (forward) Battery voltage RR (backward) 0
Is the inspection result normal?
YES
Replace sliding motor LH. Refer to REMOVAL AND INSTALLATION .
NO
GO TO STEP 2 .
- CHECK SLIDING MOTOR LH CIRCUIT
- Turn ignition switch OFF.
- Disconnect driver seat control unit and sliding motor LH.
- Check continuity between driver seat control unit harness connector and sliding motor LH harness connector.
Driver seat control unit Sliding motor LH Continuity Connector Terminal Connector Terminal B210 36 B211 1 Yes 44 5 - Check continuity between driver seat control unit harness connector and ground.
Driver seat control unit connector Ground Continuity Connector Terminal B210 36 No 44
Is the inspection result normal?
YES
GO TO STEP 3.
NO
Repair or replace harness.
- CHECK INTERMITTENT INCIDENT
Refer to INTERMITTENT INCIDENT .
Is the inspection result normal?
YES
Replace driver seat control unit. Refer to REMOVAL AND INSTALLATION .
NO
Repair or replace the malfunctioning part.