LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Automatic Drive Positioner (DTC/Circuit Diagnosis) (Except Hybrid)) >> DTC/Circuit Diagnosis >> DTC B2116: Tilt Motor >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

Regarding Wiring Diagram information, refer to WIRING DIAGRAM .

  1. PERFORM DTC CONFIRMATION PROCEDURE

    1. Turn ignition switch ON.
    2. Check "Self diagnostic result" with CONSULT.
    3. Erase the DTC.
    4. Perform DTC confirmation procedure. Refer to DTC LOGIC .

    Is the DTC displayed again?

    YES 

    GO TO STEP 2. 

    NO 

    Check intermittent incident. Refer to INTERMITTENT INCIDENT .

  2. CHECK TILT MOTOR CIRCUIT (POWER SHORT)

    1. Turn ignition switch OFF.
    2. Disconnect automatic drive positioner control unit and tilt motor connector.
    3. Check voltage between tilt motor harness connector and ground.
    (+) (+)-) Voltage (V)
    (Approx.)
    Tilt motor
    Connector Terminals
    M85 1 Ground 0
    2

    Is the inspection result normal?

    YES 

    GO TO STEP 3  .

    NO 

    Repair or replace harness or connector.

  3. CHECK AUTOMATIC DRIVE POSITIONER CONTROL UNIT OUTPUT SIGNAL

    1. Connect automatic drive positioner control unit connector.
    2. Check voltage between automatic drive positioner control unit harness connector and ground.
    (+) (+)-) Voltage (V)
    (Approx.)
    Automatic drive positioner control unit
    Connector Terminals
    M34 28 Ground 0
    29

    Is the inspection result normal?

    YES 

    Check intermittent incident  . Refer to INTERMITTENT INCIDENT

    NO 

    Replace automatic drive positioner control unit. Refer to REMOVAL AND INSTALLATION .

scientia non olet · About LEMON Manuals