Work Procedure

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

WRITING MODE SELECTION

CONSULT Configuration

Select "Re/programming, Configuration" of CAN gateway.

When writing saved data

GO TO STEP 2 .

When writing manually

GO TO STEP 3 .

PERFORM "AFTER REPLACE ECU" OF "READ / WRITE CONFIGURATION"

CONSULT Configuration

Perform "After Replace ECU" of "Read / Write Configuration".

GO TO STEP 4 .

PERFORM "MANUAL CONFIGURATION"

CONSULT Configuration
1. Select "Manual Configuration".
2. Touch "Next".
3. Touch "OK".
4. Check that the configuration has been successfully written and touch "End".
GO TO STEP 4 .

CHECK ALL ECU SELF - DIAGNOSIS RESULTS
1. Erase all ECU self - diagnosis results using CONSULT.
2. Turn the ignition switch OFF.
3. Turn the ignition switch ON and wait for 2 seconds or more.
4. Check that all ECU self - diagnosis results have no DTC (e.g. U1000 and U1001) of CAN communication.
WORK END