Removal And Installation - Outer Socket: Installation

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

Install outer socket to inner socket.

Courtesy of
Adjust inner socket to standard length (L), and then tighten inner socket lock nut to the specified torque. Refer to EXPLODED VIEW . Check length of inner socket (L) again after tightening inner socket lock nut. Make sure that the length is the standard.

Inner socket length (L) : Refer to POWER STEERING GEAR .
CAUTION:
- To prevent damage, hold outer socket across flats using suitable tool while tightening inner socket lock nut.
- Adjust toe-in after this procedure. The length achieved after toe-in adjustment is not necessarily the above value.
- Inspect to make sure no boot deformation has occurred during toe-in adjustment. Adjust boot as necessary.
Install outer socket to steering knuckle.
Install outer socket nut to outer socket. Refer to EXPLODED VIEW .
Install cotter pin to outer socket stud hole.
WARNING:
After torquing the outer socket nuts, be sure to install the cotter pins through the outer socket stud holes and bend the cotter pins around the outer socket studs.

CAUTION:
Do not reuse cotter pin.
Install front wheel and tire. Refer to ADJUSTMENT .
Check wheel alignment. Refer to INSPECTION AND ADJUSTMENT .
Adjust the neutral position of the steering angle sensor. Refer to DESCRIPTION .