LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Steering System (Except Hybrid)) >> DTC/Circuit Diagnosis >> Heated Steering Wheel System >> Component Inspection (Heated Steering Wheel)

Component Inspection (Heated Steering Wheel)

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. CHECK HEATED STEERING WHEEL CONTINUITY

    1. Turn ignition switch OFF.
    2. Remove the steering wheel. Refer to REMOVAL AND INSTALLATION .
    3. Check continuity between steering wheel connector terminals.
      Terminals Condition Continuity
      1 - 2 Surface temperature of less than 30°C (86°F) Yes
      Surface temperature of 30°C (86°F) or more No

    Is the inspection result normal?

    YES 

    GO TO STEP 2  .

    NO 

    Replace heated steering wheel.

  2. CHECK HEATED STEERING WHEEL RESISTANCE

    Check resistance between heated steering wheel connector terminals.

    Terminals Condition Resistance
    1 - 2 Surface temperature of 20°C (68°F) 1.7 - 2.17 Ω

    Is the inspection result normal?

    YES 

    Inspection End.

    NO 

    Replace heated steering wheel.

scientia non olet · About LEMON Manuals