Diagnostic Test
WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- PERFORM SELF-DIAGNOSIS
With CONSULT
- Turn the ignition switch OFF to ON.
- Perform "EPS" self-diagnosis.
Is any DTC detected?
YES
Check the DTC. Refer to DTC INDEX .
NO
GO TO STEP 2 .
- CHECK HYDRAULIC PUMP ELECTRIC POWER STEERING WARNING LAMP SIGNAL
- Turn the ignition switch ON.
- Select "WARNING LAMP" in "DATA MONITOR" of "EPS".
- Check that the item in "DATA MONITOR" is "On".CAUTION:
The engine should not be running for step 3.
- Start the engine.CAUTION:
Never drive the vehicle during the test.
- Check that the item in "DATA MONITOR" is "Off".
Is the inspection result normal?
YES
Perform the trouble diagnosis for combination meter power supply circuit. Refer to DIAGNOSIS PROCEDURE .
NO
GO TO STEP 3 .
- CHECK TERMINALS AND HARNESS CONNECTORS
Check the power steering control module pin terminals for damage or loose connection with harness connector.
Is the inspection result normal?
YES
Power steering control module is malfunctioning. Replace power steering oil pump assembly. Refer to REMOVAL AND INSTALLATION .
NO
Repair or replace the malfunctioning component.