LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Brake Control System (DTC/Circuit Diagnosis) (Without ICC) (Except Hybrid)) >> DTC/Circuit Diagnosis >> DTC C1116: Stop Lamp Switch >> DTC Description >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. PRECONDITIONING

    If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn the ignition switch OFF and wait at least 10 seconds before conducting the next test.

    GO TO STEP 2  .

  2. CHECK DTC DETECTION

    G-20 CONSULT

    1. Turn the ignition switch OFF, and wait 10 seconds or more.
    2. Start the engine.
      NOTE:

      Stop the vehicle.

    3. Wait 1 minute or more.
      NOTE:

      Never depress brake pedal.

    4. Depress brake pedal by 100 mm (3.94 in) or more, and maintain at that position for a minimum of 1 minute or more.
    5. Release brake pedal, and wait 1 minute or more.
    6. Repeat step 4 to 5 ten or more times.
    7. Turn the ignition switch OFF.
      NOTE:

      Wait at least 10 seconds after turning ignition switch OFF.

    8. Start the engine.
      NOTE:

      Wait at least 10 seconds after starting the engine.

    9. Select "Self Diagnostic Result" mode of "ABS".

    Is DTC "C1116" detected?

    YES - 1 

    "C1116" is displayed as "CRNT": Proceed to DIAGNOSIS PROCEDURE .

    YES - 2 

    "C1116" is displayed as "PAST": Inspection End (Erase "Self Diagnostic Result" of "ABS").

    NO-1 

    To check malfunction symptom before repair: Refer to CIRCUIT INSPECTION .

    NO-2 

    Confirmation after repair: Inspection End.

scientia non olet · About LEMON Manuals