DTC Confirmation Procedure

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

PRECONDITIONING

If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn the ignition switch OFF and wait at least 10 seconds before conducting the next test.

GO TO STEP 2 .

CHECK DTC DETECTION

With CONSULT
1. Start the engine.
2. Drive the vehicle at approx. 50 km/h (31 MPH) or more for approx. 2 minutes.
3. Stop the vehicle.
4. Turn the ignition switch OFF.
  NOTE:
  Wait at least 10 seconds after turning ignition switch OFF.
5. Start the engine.
  NOTE:
  Wait at least 10 seconds after starting the engine.
6. Perform "Self Diagnostic Result" of "ABS".
Is DTC "C1115" detected?

YES - 1

"C1115" is displayed as "CRNT": Proceed to DIAGNOSIS PROCEDURE .

YES - 2

"C1115" is displayed as "PAST": Inspection End (Erase "Self Diagnostic Result" of "ABS").

NO - 1

To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .

NO - 2

Confirmation after repair: Inspection End.