Diagnostic Test
WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK CONNECTOR
- Turn the ignition switch OFF.
- Check the ABS actuator and electric unit (control unit) harness connector for disconnection or looseness.
Is the inspection result normal?
YES
GO TO STEP 3 .
NO
Repair / replace harness or connector, securely lock the connector, and GO TO STEP 2 .
- PERFORM SELF-DIAGNOSIS
- Turn the ignition switch OFF.NOTE:
Wait at least 10 seconds after turning ignition switch OFF.
- Start the engine.NOTE:
Wait at least 10 seconds after starting the engine.
- Select "Self Diagnostic Result" mode of "ABS".
Is DTC "C1109" detected?
YES
GO TO STEP 3 .
NO
Inspection End.
- Turn the ignition switch OFF.
- CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY AND GROUND CIRCUIT
Check the ABS actuator and electric unit (control unit) power supply and ground circuits. Refer to DIAGNOSIS PROCEDURE .
Is the inspection result normal?
YES
GO TO STEP 4 .
NO
Repair / replace harness, connector, fuse, or fusible link.
- CHECK TERMINAL
- Check the ABS actuator and electric unit (control unit) pin terminals for damage or loose connection with harness connector.
- Check the IPDM E/R pin terminals for damage or loose connection with harness connector.
Is the inspection result normal?
YES
Replace the ABS actuator and electric unit (control unit). Refer to REMOVAL AND INSTALLATION .
NO
Repair / replace harness, connector, or terminal.