LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Transfer Case (Except Hybrid)) >> Unit Disassembly And Assembly >> Drive Pinion >> Disassembly

Drive Pinion: Disassembly

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove pinion bearing assembly mounting bolts.
    G08856137Courtesy of NISSAN NORTH AMERICA, INC.
  2. Lightly tap companion flange with a plastic hammer to remove drive pinion assembly (1).
    G08856138Courtesy of NISSAN NORTH AMERICA, INC.
  3. Remove the O-ring from pinion bearing.
  4. Remove the pinion lock nut.
  5. Remove drive pinion from pinion bearing assembly with drift (A) (commercial service tool) and replacer (B) (commercial service tool).
    G08856139Courtesy of NISSAN NORTH AMERICA, INC.
  6. Remove adjusting shim.
  7. Remove companion flange.
  8. Remove the dust cover.
  9. Remove the oil seal.
  10. Perform inspection after disassembly. Refer to INSPECTION .
scientia non olet · About LEMON Manuals