LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Transfer Case (Except Hybrid)) >> System Description >> Diagnosis System (AWD Control Unit) >> Consult Function >> Active Test

Active Test

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

Use this mode to determine and identify the details of a malfunction based on self-diagnostic results or data monitor. AWD control unit gives drive signal to actuator with receiving command from CONSULT to check operation of actuator.

Test item Condition Description
ETS S/V
(Detects AWD solenoid)
  • Vehicle stopped
  • Engine running
  • No DTC detected
 Change command current value to AWD solenoid, and then change driving mode. (Monitor value is normal if it is within approx. +-10% of command value.)
  • Qu: Increase current value in increments of 0.2 A
  • Qd: Decrease current value in increments of 0.2 A
  • UP: Increase current value in increments of 0.02 A
  • DOWN: Decrease current value in increments of 0.02 A
CAUTION:

Never energize continuously for a long time.

scientia non olet · About LEMON Manuals