LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Transfer Case (Except Hybrid)) >> Basic Inspection >> Unit Characteristics Writing >> Work Procedure

Work Procedure

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. UNIT CHARACTERISTICS WRITING

    G-20With CONSULT 

    1. Confirm the unit characteristics (A) of electric controlled coupling.
      G08855997Courtesy of NISSAN NORTH AMERICA, INC.
      NOTE:

      Unit characteristics is 12-digit alphanumeric.

    2. Turn the ignition switch OFF to ON.
    3. Select "UNIT CHARACTERISTICS WRITE" in "WORK SUPPORT" for "ALL MODE AWD/4WD".
    4. Input unit characteristics.
    5. Select "Start".
    6. Check that "UNIT CHARACTERISTICS WRITE COMPLETED" is displayed.

    WORK END