Front Coil Spring And Strut: Disposal
WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- Set strut assembly horizontally with the piston rod fully extended.
- Drill 2 - 3 mm (0.08 - 0.12 in) hole at the position (
) from top as shown below to release gas gradually.
CAUTION:- Wear eye protection (safety glasses).
- Wear gloves.
- Be careful with metal chips or oil blown out by the compressed gas.
NOTE:- Drill vertically in this direction (
) directly to the outer tube avoiding brackets.
- The gas is clear, colorless, odorless, and harmless.
(A) : 20 - 30 mm (0.79 - 1.18 in) - Position the drilled hole downward and drain oil by moving the piston rod several times.CAUTION:
Dispose of drained oil according to the law and local regulations.