LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 75 (Front Axle (Except Hybrid)) >> Unit Disassembly And Assembly >> Front Drive Shaft >> Disassembly And Assembly (RH) >> Disassembly >> Transaxle Side

Transaxle Side

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Press shaft in a vise.
    CAUTION:

    When retaining shaft in a vise, always use copper or aluminum plates between vise and shaft.

  2. Remove circlip and dust shield from slide joint housing.
  3. Remove boot bands and slide the boots back.
  4. Put matching marks on slide joint housing and shaft before separating slide joint housing.
  5. Remove stopper ring using a suitable tool, then pull out slide joint housing.
    G04150370Courtesy of NISSAN NORTH AMERICA, INC.
  6. Put matching mark (A) on spider assembly and shaft.
    G05224276Courtesy of NISSAN NORTH AMERICA, INC.
  7. Remove snap ring (1) using a suitable tool, then remove spider assembly from shaft.
    G05224277Courtesy of NISSAN NORTH AMERICA, INC.
  8. Remove boot from shaft.
  9. Clean old grease off of the slide joint housing.
scientia non olet · About LEMON Manuals