LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Brake Control System (DTC/Circuit Diagnosis) (With ICC) (Except Hybrid) (1 Of 2)) >> DTC/Circuit Diagnosis >> DTC C1101, C1102, C1103, C1104: Wheel Sensor >> DTC Description >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. PRECONDITIONING

    If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn the ignition switch OFF and wait at least 10 seconds before conducting the next test.

    GO TO STEP 2  .

  2. CHECK DTC DETECTION

    G-20 CONSULT

    1. Start the engine.
    2. Drive the vehicle at approx. 50 km/h (31 MPH) or more for approx. 2 minutes.
    3. Stop the vehicle.
    4. Turn the ignition switch OFF.
      NOTE:

      Wait at least 10 seconds after turning ignition switch OFF.

    5. Start the engine.
      NOTE:

      Wait at least 10 seconds after starting the engine.

    6. Select "Self Diagnostic Result" mode of "ABS".

    Is DTC "C1101", "C1102", "C1103" or "C1104" detected?

    YES - 1 

    "C1101", "C1102", "C1103" or "C1104" is displayed as "CRNT": Proceed to DIAGNOSIS PROCEDURE .

    YES - 2 

    "C1101", "C1102", "C1103" or "C1104" is displayed as "PAST": Inspection End (Erase "Self Diagnostic Result" of "ABS").

    NO - 1 

    To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .

    NO - 2 

    Confirmation after repair: Inspection End.

scientia non olet · About LEMON Manuals