LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Audio, Visual & Navigation System (Introduction, Wiring Diagrams And Basic Inspection) (BOSE Audio W/NAVI W/O Surround) (Except Hybrid)) >> Basic Inspection >> Inspection And Adjustment >> Additional Service When Replacing Sonar Control Unit >> Work Procedure >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. SAVING VEHICLE SPECIFICATION

    G-20 - CONSULT

    Enter "Re/Programming, Configuration" and perform "Before Replace ECU" to save or print current vehicle specification.

    NOTE:

    If "Before Replace ECU" cannot be used, use the "After Replace ECU" or "Manual Configuration" after replacing sonar control unit.

    GO TO STEP 2  .

  2. REPLACE SONAR CONTROL UNIT

    Replace sonar control unit. Refer to REMOVAL AND INSTALLATION .

    GO TO STEP 3  .

  3. WRITING VEHICLE SPECIFICATION

    G-20 CONSULT

    1. Enter "Re/Programming, Configuration".
    2. If "Before Replace ECU" operation was performed, automatically an "Operation Log Selection" screen will be displayed. Select the applicable file from the "Saved Data List" and press "Confirm" to write vehicle specification. Refer to WORK PROCEDURE .
    3. If "Before Replace ECU" operation was not performed, select "After Replace ECU" or "Manual Configuration" to write vehicle specification. Refer to WORK PROCEDURE .

    GO TO STEP 4  .

  4. OPERATION CHECK

    Check that the operation of the sonar control unit is normal.

    Work End.

scientia non olet · About LEMON Manuals