LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Exterior Lighting System (Except Hybrid)) >> Unit Disassembly And Assembly >> Front Combination Lamp >> Disassembly And Assembly >> Disassembly

Disassembly And Assembly: Disassembly

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Do not touch bulb by hand while it is lit or right after being turned off. Burning may result.

CAUTION:
  • Disconnect the negative battery terminal or remove the fuse.
  • Do not touch glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to bulb.
  • Do not leave the bulb out of the lamp reflector for a long time because dust, moisture, smoke, etc. may affect the performance of the lamp.
CAUTION:

HID control unit and xenon bulb socket cannot be disassembled.

  1. Remove front combination lamp. Refer to REMOVAL AND INSTALLATION .
  2. Rotate plastic cover counterclockwise and remove.
  3. Rotate xenon bulb socket counterclockwise and remove.
  4. Unlock retaining spring and remove xenon bulb.
  5. Rotate front turn signal lamp socket counterclockwise and remove.
  6. Remove front turn signal lamp bulb from front turn signal lamp socket.
scientia non olet · About LEMON Manuals