Diagnosis Procedure

Regarding Wiring Diagram information, refer to WIRING DIAGRAM .

1. CHECK DAYTIME RUNNING LIGHT RELAY VOLTAGE SUPPLY
   
   
   1. Turn the ignition switch OFF.
   2. Disconnect the daytime running light relay harness connector E4.
   3. Turn the ignition switch ON.
   4. Check the voltage between the following daytime running light relay harness connector E4 terminals and ground.

      (+)			(-)	Voltage
      Connector		Terminal
      E4		2	Ground	Battery voltage
      		5
      		7

   Is the inspection results normal?

   YES 

   GO TO STEP 3  .

   NO 

   GO TO STEP 2  .

2. CHECK DAYTIME RUNNING LIGHT RELAY CIRCUIT
   
   
   1. Turn the ignition switch OFF.
   2. Disconnect IPDM E/R harness connector E121.
   3. Check continuity between the IPDM E/R harness connector E121 and the daytime running light relay harness connector E4.

      Daytime running light relay		IPDM E/R		Continuity
      Connector	Terminal	Connector	Terminal
      E4	2	E121	14	Yes
      	5
      	7

   4. Check continuity between the IPDM E/R harness connector E121 and ground.

      Connector		Terminal	(-)	Continuity
      E121		14	Ground	No

   Is the inspection results normal?

   YES 

   Replace IPDM E/R. Refer to REMOVAL AND INSTALLATION .

   NO 

   Repair or replace the harnesses or connectors.

3. CHECK DAYTIME RUNNING LAMP RELAY COIL CIRCUIT
   
   
   1. Check continuity between the IPDM E/R harness connector E218 and daytime running light relay harness connector E4.

      IPDM E/R			Daytime running light relay		Continuity
      Connector		Terminal	Connector	Terminal
      E218		85	E4	1	Yes

   2. Check continuity between the IPDM E/R harness connector E218 and ground.

      Connector		Terminal	Ground	Continuity
      E218		85		No

   Does continuity exist?

   YES 

   GO TO 4.

   NO 

   Repair or replace the harnesses or connectors.

4. CHECK DAYTIME RUNNING LIGHT RELAY
   
   

   Check the daytime running light relay. Refer to COMPONENT INSPECTION .

   Is the inspection results normal?

   YES 

   GO TO 5.

   NO 

   Replace relay.

5. CHECK DAYTIME RUNNING LAMP CIRCUIT FOR OPEN
   
   
   1. Turn the ignition switch OFF.
   2. Disconnect the front combination lamp harness connector E234 or E239 in question.
   3. Check continuity between the daytime running light relay harness connector E4 and the front combination lamp harness connector E234 or E239.

      Front combination lamp			Daytime running light relay		Continuity
      Connector		Terminal	Connector	Terminal
      LH E234		7	E4	6	Yes
      RH E239				3

   Is the inspection results normal?

   YES 

   GO TO 6.

   NO 

   Repair or replace the harnesses or connectors.

6. CHECK DAYTIME RUNNING LAMP GROUND CIRCUIT FOR OPEN
   
   
   1. Turn the ignition switch OFF.
   2. Disconnect front combination lamp harness connector E234 or E239 in question.
   3. Check continuity between the front combination lamp harness connector E234 or E239 terminal 3 and ground.

      Connector		Terminal	(-)	Continuity
      LH E234		3	Ground	Yes
      RH E239

   Does continuity exist?

   YES 

   Inspection End.

   NO 

   Repair or replace the harnesses or connectors.