Diagnostic Test

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side).
  - TCM
  - Harness connector F32
  - Harness connector E2
Is the inspection result normal?

YES

GO TO STEP 2 .

NO

Repair the terminal and connector.

CHECK HARNESS FOR OPEN CIRCUIT

Disconnect the connector of TCM.

Check the resistance between the TCM harness connector terminals.

Except for Mexico

TCM harness connector			Resistance (Ω)
Connector No.	Terminal No.
F89	33	23	Approx. 54 - 66

Is the measurement value within the specification?

YES

GO TO STEP 3 .

Repair the TCM branch line.

CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the TCM. Refer to the following.
- RE0F10E: DIAGNOSIS PROCEDURE .
- RE0F10J: DIAGNOSIS PROCEDURE .
Is the inspection result normal?

YES (Present error)

Replace the TCM. Refer to the following.
- RE0F10E: REMOVAL AND INSTALLATION .
- RE0F10J: REMOVAL AND INSTALLATION .
YES (Past error)

Error was detected in the TCM branch line.

NO

Repair the power supply and the ground circuit.