DTC Confirmation Procedure
WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- PERFORM DTC CONFIRMATION PROCEDURE (1)
- Start the engine.
- Perform the active test item "STOP LAMP" with CONSULT.
- Perform "All DTC Reading".
- Check if the "C1A13" is detected as the current malfunction in the "Self Diagnostic Result" of "ICC/ADAS".
Is "C1A13" detected as the current malfunction?
YES
Refer to DIAGNOSIS PROCEDURE .
NO
GO TO STEP 2.
- PERFORM DTC CONFIRMATION PROCEDURE (2)
- Drive at the vehicle speed of 40 km/h (25 MPH) or more for approximately 60 seconds or more without the brake pedal depressed.CAUTION:
Always drive safely.
NOTE:If it is outside the above condition, repeat step 1.
- Perform "All DTC Reading".
- Check if the "C1A13" is detected as the current malfunction in the "Self Diagnostic Result" of "ICC/ADAS".
Is "C1A13" detected as the current malfunction?
YES
Refer to DIAGNOSIS PROCEDURE .
NO
Refer to INTERMITTENT INCIDENT .
- Drive at the vehicle speed of 40 km/h (25 MPH) or more for approximately 60 seconds or more without the brake pedal depressed.