Brake Actuator
WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The test can be performed only when the engine is running.
| Test item | Operation | Description | "PRESS SENS" value |
|---|---|---|---|
| BRAKE ACTUATOR | MODE1 | Transmits the brake fluid pressure control signal to the ABS actuator and electric unit (control unit) via CAN communication | 10 bar |
| MODE2 | 20 bar | ||
| MODE3 | 30 bar | ||
| Test start | Starts the tests of "MODE1", "MODE2" and "MODE3" | - | |
| Reset | Stops transmitting the brake fluid pressure control signal below to end the test | - | |
| End | Returns to the "SELECT TEST ITEM" screen | - |
NOTE:
The test is finished in 10 seconds after starting