Component Description

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

Component	Description
ADAS control unit	Judges lane departure based on each signal and calculates yaw moment necessary to generate force toward the direction to recover the vehicle from the lane departure Transmits a warning buzzer request signal to the driver assistance buzzer control module Transmits a target yaw moment signal to the ABS actuator and electric unit (control unit) via CAN communication Transmits the lane departure warning lamp signal and LDP ON indicator lamp signal to combination meter via CAN communication
Lane camera unit	Detects the lane marker in travel lane Transmits the detected lane condition signal to ADAS control unit via ITS communication
ABS actuator and electric unit (control unit)	Transmits the vehicle speed signal (wheel speed) to ADAS control unit via CAN communication Transmits the yaw rate signal and side G sensor signal to ADAS control unit via CAN communication Receives a target yaw moment signal from the ADAS control unit via CAN communication and controls brake pressure of four wheels, respectively
Dynamic driver assistance switch (On the ICC steering switch)	ECM receives an ICC steering switch (dynamic driver assistance switch) signal and transmits the signal to ADAS control unit via CAN communication
Combination meter	Turns on the following indicator/warning lamp, according to a signal received for the ADAS control unit via CAN communication LDP ON indicator lamp (Green) Lane departure warning indicator light (Yellow) Transmits the system selection signal to ADAS control unit via CAN communication
BCM	Transmits the turn indicator signal to ADAS control unit via CAN communication
ECM	Transmits the accelerator pedal position signal, engine speed signal and ICC steering switch signal (dynamic driver assistance switch signal) to ADAS control unit via CAN communication
Steering angle sensor	Transmits the steering angle sensor signal to ADAS control unit via CAN communication
TCM	Transmits the output shaft revolution signal, input speed signal, current gear position signal and shift position signal to ADAS control unit via CAN communication
Driver assistance buzzer control module	Receives warning buzzer request signal to activate warning buzzer Transmits a warning buzzer signal to the warning buzzer
Warning buzzer	When a warning buzzer signal is received from driver assistance buzzer control module, the buzzer sounds