Diagnosis Procedure
WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK LDP SYSTEM SETTING
- Start the engine.
- Check that the LDP system settings is selectable in the vehicle information display.
Is the inspection result normal?
YES
GO TO STEP 3.
NO
GO TO STEP 2.
- PERFORM THE SELF-DIAGNOSIS
- Perform "All DTC Reading" with CONSULT.
- Check if the DTC is detected in self-diagnosis results of "ICC/ADAS" and "METER/M&A". Refer to the following.
Is any DTC detected?
YES
Repair or replace malfunctioning parts.
NO
INSPECTION END
- CHECK DATA MONITOR OF ADAS CONTROL UNIT
Check that "LDP SELECT" operates normally in "DATA MONITOR" of "ICC/ADAS" with CONSULT.
Is the inspection result normal?
YES
Refer to SYSTEM DESCRIPTION .
NO
GO TO STEP 4.
- CHECK THE VEHICLE INFORMATION DISPLAY SWITCH
Operate the vehicle information display switch to check that the vehicle information display operates properly.
Is the inspection result normal?
YES
Replace the ADAS control unit. Refer to REMOVAL AND INSTALLATION .
NO
Repair or replace malfunctioning parts.