Seat Cushion: Assembly

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

Assembly is in the reverse order of disassembly.

Install new hog rings on the seat cushion trim in original positions.

Courtesy of NISSAN NORTH AMERICA, INC.
Use only one hog ring in each designated location.
Make sure hog rings are correctly fastened around both the seat cushion trim and seat cushion pad wires.
Use INFINITI standard hog rings and tools to assemble.
Make sure hook fastener is pressed into place after seat cushion trim is assembled.
Smooth out all wrinkles during assembly.

CAUTION:

Always route side air bag module harness in original location. Replace any deformed or damaged clips with same type and color. Always install clips in the original location in the harness.
After work is completed, check that no system malfunction is detected causing the air bag warning lamp to illuminate.
If a malfunction is detected by the air bag warning lamp after repair or replacement of the malfunction parts, perform the SRS final check. Refer to SRS FINAL CHECK .