Diagnosis Procedure
WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
Regarding Wiring Diagram information, refer to WIRING DIAGRAM .
- CHECK FUSE
Check that the following fuses are not blown.
Terminal No. Signal name Fuse No. 68 Ignition signal 29 (5A) 19 Battery power supply 15 (15A) 7 ACC power supply 65 (10A) Are the fuses blown?
YES
Replace the blown fuse after repairing the affected circuit.
NO
GO TO STEP 2 .
- CHECK POWER SUPPLY CIRCUIT
- Turn ignition switch OFF.
- Disconnect AV control unit connectors M161 and M163.
- Check voltage between AV control unit connectors and ground.
AV control unit Ground Condition Voltage
(Approx.)Connector Terminal M163 68 - Ignition switch: ON Battery voltage M161 7 Ignition switch: ACC 19 Ignition switch: OFF
Is the inspection result normal?
YES
GO TO STEP 3 .
NO
Repair or replace harness or connectors.
- CHECK GROUND CIRCUIT
- Turn ignition switch OFF.
- Check continuity between AV control unit connector M161 terminal 20 and ground.
AV control unit Ground Continuity Connector Terminal M161 20 - Yes
Is the inspection result normal?
YES
Inspection End.
NO
Repair or replace harness or connectors.