Error History
The self - diagnosis results are judged depending on whether any error occurs from when "Self - diagnosis" is selected until the self - diagnosis results are displayed.
However, the diagnosis results are judged normal if an error has occurred before the ignition switch is turned ON and then no error has occurred until the self - diagnosis start. Check the "Error Record" to detect any error that may have occurred before the self - diagnosis start because of this situation.
The error record displays the time and place of the most recent occurrence of that error. However, take note of the following points.
- If there is a malfunction with the GPS antenna circuit board in the AV control unit, the correct date and time of occurrence may not be able to be displayed.
- Place of the error occurrence is represented by the position of the current location mark at the time an error occurred. If current location mark has deviated from the correct position, then the place of the error occurrence cannot be located correctly.
- The frequency of occurrence is displayed in a count up manner. The actual count up method differs depending on the error item.
Count up method A
- The counter resets to 0 if an error occurs when ignition switch is turned ON. The counter increases by 1 if the condition is normal at a next ignition ON cycle.
- The counter upper limit is 39. Any counts exceeding 39 are ignored." The counter can be reset (no error record display) with the "Delete log" switch or CONSULT.
Count up method B
- The counter increases by 1 if an error occurs when ignition switch is ON. The counter will not decrease even if the condition is normal at the next ignition ON cycle.
- The counter upper limit is 50. Any counts exceeding 50 are ignored. " The counter can be reset (no error record display) with the "Delete log" switch or CONSULT.
| Display type of occurrence frequency | Error history display item |
|---|---|
| Count up method A | CAN communication line, control unit (CAN), AV communication line, control unit (AV) |
| Count up method B | Other than the above |
Error item
Some error items may be displayed simultaneously according to the cause. If some error items are displayed simultaneously, the detection of the cause can be performed by the combination of display items
| Error item | Description | Possible malfunction factor/Action to take |
|---|---|---|
| CAN COMM CIRCUIT | CAN communication malfunction is detected. | Perform diagnosis with CONSULT, and then repair the malfunctioning parts according to the diagnosis results. Refer to CONSULT FUNCTION . |
| CONTROL UNIT (CAN) | CAN initial diagnosis malfunction is detected. | Replace the AV control unit if the malfunction occurs constantly. Refer to REMOVAL AND INSTALLATION . |
| CONTROL UNIT (AV) | AV communication circuit initial diagnosis malfunction is detected. | |
| FLASH - ROM Error Of Control Unit | AV control unit malfunction is detected. | |
| Connection Of Gyro | ||
| Connection of G Sensor | ||
| CAN Controller Memory Error | ||
| Bluetooth® Module Connection Error | ||
| Sub CPU Connection Error | ||
| Audio connection error | ||
| DSP Connection Error | AV control unit malfunction is detected. |
|
| DSP Communication Error | ||
| HDD Connection Error | AV control unit malfunction is detected. |
|
| HDD Read Error | ||
| HDD Write Error | ||
| HDD Communication Error | ||
| HDD Access Error | ||
| GPS Communication Error | GPS malfunction is detected. |
|
| GPS ROM Error | ||
| GPS RAM Error | ||
| GPS RTC Error | ||
| Unfinished configuration | The writing of configuration data is incomplete. | Write configuration data with CONSULT. |
| USB Controller Communication Error | USB connection malfunction is detected. | Check that the connection to the USB connector is normal. |
| DVD Mechanism Communication Error | AV control unit malfunction is detected. |
|
| Steer. Angle Sensor Calibration | Predictive course line center position adjustment of the steering angle sensor is incomplete. | Adjust the predictive course line center position of the steering angle sensor. Refer to WORK PROCEDURE . |
| Amplifier Temperature Error | BOSE amp. malfunction is detected. | Replace the BOSE amp. Refer to REMOVAL AND INSTALLATION . |
| Front Display Connection Error | When either one of the following items are detected:
|
|
|
When either one of the following items are detected:
|
|
| 3rd Display Connection Error | When either one of the following items are detected:
|
|
| AM/FM antenna amplifier short to ground | Radio antenna amp. ON signal circuit malfunction is detected. | Radio antenna amp. ON signal circuit between AV control unit and antenna amp. |
| AM/FM antenna amplifier open | ||
| Ext_Amp_ON output terminal short to ground | BOSE amp. ON signal circuit malfunction is detected. | BOSE amp. ON signal circuit between AV control unit and BOSE amp. |
| Ext_Amp_ON output terminal :open | ||
| GPS Antenna Error | GPS antenna connection malfunction is detected. | Check the connection of the GPS antenna connector. |
| XM Antenna Connection Error | Satellite radio antenna connection malfunction is detected. | Satellite radio antenna disconnection. |
| USB electric current Error | Detection of overcurrent in USB connector. | Check USB harness between the AV control unit and USB connector. |
| FL-DOOR SPEAKER OUT: open | When either one of the following items are detected:
|
|
| FL-DOOR SPEAKER OUT: short | ||
| FL-DOOR SPEAKER: short to ground | ||
| FL-DOOR SPEAKER: short to battery | ||
| FL-DOOR TWEETER OUT: open | ||
| FL-DOOR TWEETER OUT: short | ||
| FL-DOOR TWEETER OUT: short to ground | ||
| FL-DOOR TWEETER OUT: short to battery | ||
| FR-DOOR SPEAKER OUT: open | When either one of the following items are detected:
|
|
| FR-DOOR SPEAKER OUT: short | ||
| FR-DOOR SPEAKER OUT: short to ground | ||
| FR-DOOR SPEAKER OUT: short to battery | ||
| FR-DOOR TWEETER OUT: open | ||
| FR-DOOR TWEETER OUT: short | ||
| FR-DOOR TWEETER OUT: short to ground | ||
| FR-DOOR TWEETER OUT: short to battery | ||
| FL-INST TWEETER OUT: open | Sound signal circuits between BOSE amp. and tweeter LH are malfunctioning. | Sound signal circuits between BOSE amp. and tweeter LH. |
| FL-INST TWEETER OUT: short | ||
| FL-INST TWEETER OUT: short to ground | ||
| FL-INST TWEETER OUT: short to battery | ||
| FC-INST SPEAKER OUT: open | Malfunction is detected sound signal circuits between BOSE amp. and center speaker. | Sound signal circuits between BOSE amp. and center speaker. |
| FC-INST SPEAKER OUT: short | ||
| FC-INST SPEAKER OUT: short to ground | ||
| FC-INST SPEAKER OUT: short to battery | ||
| FR-INST TWEETER OUT: open | Sound signal circuits between BOSE amp. and tweeter RH are malfunctioning. | Sound signal circuits between BOSE amp. and tweeter RH. |
| FR-INST TWEETER OUT: short | ||
| FR-INST TWEETER OUT: short to ground | ||
| FR-INST TWEETER OUT: short to battery | ||
| 2L-DOOR SPEAKER OUT: open | When either one of the following items are detected:
|
|
| 2L-DOOR SPEAKER OUT: short | ||
| 2L-DOOR SPEAKER OUT: short to ground | ||
| 2L-DOOR SPEAKER OUT: short to battery | ||
| 2L-DOOR TWEETER OUT: open | ||
| 2L-DOOR TWEETER OUT: short | ||
| 2L-DOOR TWEETER OUT: short to ground | ||
| 2L-DOOR TWEETER OUT: short to battery | ||
| 2R-DOOR SPEAKER OUT: open | When either one of the following items are detected:
|
|
| 2R-DOOR SPEAKER OUT: short | ||
| 2R-DOOR SPEAKER OUT: short to ground | ||
| 2R-DOOR SPEAKER OUT: short to battery | ||
| 2R-DOOR TWEETER OUT: open | ||
| 2R-DOOR TWEETER OUT: short | ||
| 2R-DOOR TWEETER OUT: short to ground | ||
| 2R-DOOR TWEETER OUT: short to battery | ||
| RL-SPEAKER OUT: open | Sound signal circuits between BOSE amp. and rear speaker LH are malfunctioning. | Sound signal circuits between BOSE amp. and rear speaker LH. |
| RL-SPEAKER OUT: short | ||
| RL-SPEAKER OUT: short to ground | ||
| RL-SPEAKER OUT: short to battery | ||
| RR-SPEAKER OUT: open | Sound signal circuits between BOSE amp. and rear speaker RH are malfunctioning. | Sound signal circuits between BOSE amp. and rear speaker RH. |
| RR-SPEAKER OUT: short | ||
| RR-SPEAKER OUT: short to ground | ||
| RR-SPEAKER OUT: short to battery | ||
| SUBWOOFER OUT: open | Sound signal circuits between BOSE amp. and subwoofer are malfunctioning. | Sound signal circuits between BOSE amp. and subwoofer. |
| SUBWOOFER OUT: short | ||
| SUBWOOFER OUT: short to ground | ||
| SUBWOOFER OUT: short to battery | ||
|
When either one of the following items are detected:
|
|
|
When either one of the following items are detected:
|
|
|
When either one of the following items are detected:
|
|
|
When either one of the following items are detected:
|
|
|
AV communication circuits between AV control unit and multifunction switch are malfunctioning. | AV communication circuits between AV control unit and multifunction switch. |
|