Diagnosis Procedure
WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
Regarding Wiring Diagram information, refer to WIRING DIAGRAM - WITH AUTOMATIC DRIVE POSITIONER or WIRING DIAGRAM - WITHOUT AUTOMATIC DRIVE POSITIONER .
- CHECK WASHER FLUID LEVEL SWITCH SIGNAL CIRCUIT
- Turn ignition switch OFF.
- Disconnect combination meter harness connector M23 and washer fluid level switch harness connector E208.
- Check continuity between combination meter harness connector M23 and washer fluid level switch harness connector E208.
Combination meter Washer fluid level switch Continuity Connector Terminal Connector Terminal M23 49 E208 1 Yes - Check continuity between combination meter harness connector and ground.
Combination meter Ground Continuity Connector Terminal M23 49 No
Is the inspection result normal?
YES
GO TO STEP 2.
NO
Repair or replace harness or connectors.
- CHECK WASHER FLUID LEVEL SWITCH GROUND CIRCUIT
Check continuity between washer fluid level switch connector and ground.
Washer fluid level switch Ground Continuity Connector Terminal E208 2 Yes Is the inspection result normal?
YES
Inspection End.
NO
Repair or replace harness or connectors.