Component Inspection

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE FUEL LEVEL SENSOR UNIT

Remove the fuel level sensor unit. Refer to REMOVAL AND INSTALLATION .

GO TO STEP 2.

CHECK FUEL LEVEL SENSOR UNIT AND FUEL PUMP

Check the resistance between terminals 2 and 5.

Fig 1: Checking Fuel Level Sensor Unit And Fuel Pump

Courtesy of NISSAN NORTH AMERICA, INC.

Terminal		Float position mm (in)			Resistance value (Approx.)
2	5	*1	Empty	15.7 (0.6)	283Ω
2	5	*2	Full	133 (5.2)	51Ω

*1 and *2: When float arm is in contact with stopper.

Is inspection result OK?

YES

Inspection End.

Replace fuel level sensor unit and fuel pump. Refer to REMOVAL AND INSTALLATION .