Diagnostic Test
WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK SYMPTOM
Check that the vehicle jerks when VDC function, TCS function, ABS function, EBD function, hill start assist function or Brake force distribution function operates.
Is the inspection result normal?
YES
Inspection End.
NO
GO TO STEP 2 .
- PERFORM THE SELF-DIAGNOSIS
With CONSULT
Perform self-diagnosis result. Refer to CONSULT FUNCTION .
Is any DTC detected?
YES
Check the DTC. Refer to DTC INDEX .
NO
GO TO STEP 3 .
- CHECK CONNECTOR
- Turn the ignition switch OFF.
- Disconnect ABS actuator and electric unit (control unit) harness connector.
- Check connector terminal for deformation, disconnection and looseness.
- Connect harness connector and perform self-diagnosis result. Refer to CONSULT FUNCTION .
Is the inspection result normal?
YES
GO TO STEP 4 .
NO
Repair or replace connector terminal.
- CHECK ECM AND TCM SELF-DIAGNOSIS RESULTS
Perform self-diagnosis result for "ENGINE" and "TRANSMISSION".
Is any DTC detected?
YES
Check the DTC.
NO
Replace ABS actuator and electric unit (control unit). Refer to REMOVAL AND INSTALLATION .