LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Engine Control System (DTC/Circuit Diagnosis) (VQ35DE) (Except Hybrid) (1 Of 3)) >> DTC/Circuit Diagnosis >> DTC P0137, P0157: Ho2S2 >> Diagnosis Procedure >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. CLEAR MIXTURE RATIO SELF-LEARNING VALUE

    1. Clear the mixture ratio self-learning value. Refer to DESCRIPTION .
    2. Run engine for at least 10 minutes at idle speed.

    Is the 1st trip DTC P0171 or P0174 detected? Is it difficult to start engine?

    YES 

    Perform trouble diagnosis for DTC P0171 or P0174. Refer to DTC LOGIC .

    NO 

    GO TO STEP 2  .

  2. CHECK HO2S2 GROUND CIRCUIT

    1. Turn ignition switch OFF.
    2. Disconnect heated oxygen sensor 2 harness connector.
    3. Disconnect ECM harness connector.
    4. Check the continuity between heated oxygen sensor 2 (HO2S2) harness connector and ECM harness connector.
      DTC HO2S2 ECM Continuity
      Bank Connector Terminal Connector Terminal
      P0137 1 F75 4 F78 35 Existed
      P0157 2 F76 4
    5. Also check harness for short to ground and short to power.

    Is the inspection result normal?

    YES 

    GO TO STEP 3  .

    NO 

    Repair open circuit, short to ground or short to power in harness or connectors.

  3. CHECK HO2S2 INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT

    1. Check the continuity between HO2S2 harness connector and ECM harness connector.
      DTC HO2S2 ECM Continuity
      Bank Connector Terminal Connector Terminal
      P0137 1 F75 3 F78 41 Existed
      P0157 2 F76 3 32
    2. Check the continuity between HO2S2 harness connector and ground, or ECM harness connector and ground.
      DTC HO2S2 Ground Continuity
      Bank Connector Terminal
      P0137 1 F75 3 Ground Not existed
      P0157 2 F76 3
      DTC ECM Ground Continuity
      Connector Terminal
      P0137 F78 41 Ground Not existed
      P0157 32
    3. Also check harness for short to power.

    Is the inspection result normal?

    YES 

    GO TO STEP 4  .

    NO 

    Repair open circuit, short to ground or short to power in harness or connectors.

  4. CHECK HEATED OXYGEN SENSOR 2

    Check heated oxygen sensor 2. Refer to COMPONENT INSPECTION .

    Is the inspection result normal?

    YES 

    Check intermittent incident. Refer to INTERMITTENT INCIDENT .

    NO 

    Replace malfunctioning heated oxygen sensor 2. Refer to REMOVAL AND INSTALLATION (BANK 2) , REMOVAL AND INSTALLATION (BANK 1) .

scientia non olet · About LEMON Manuals