DTC Confirmation Procedure

Will CONSULT be used?

Will CONSULT be used?

YES 

GO TO STEP 2. 

NO 

GO TO STEP 5. 

If DTC confirmation Procedure has been previously conducted, always perform the following before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION: 

For better results, perform "DTC WORK SUPPORT" at a temperature of 0 to 30°C (32 to 86°F). 

GO TO STEP 3. 

With CONSULT 

1. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT.
2. Start engine and warm it up to the normal operating temperature.
3. Turn ignition switch OFF and wait at least 10 seconds.
4. Turn ignition switch ON.
5. Turn ignition switch OFF and wait at least 10 seconds.
6. Start engine and keep the engine speed between 3, 500 and 4, 000 rpm for at least 1 minute under no load.
7. Let engine idle for 1 minute.
8. Check that "COOLANT TEMP/S" indicates more than 70°C (158°F).

   If not, warm up engine and go to next step when "COOLANT TEMP/S" indication reaches 70°C (158°F).

9. Open engine hood.
10. Select "HO2S2 (B1) P1147" (for DTC P0137) or "HO2S2 (B2) P1167" (for DTC P0157) of "HO2S2" in "DTC WORK SUPPORT" mode with CONSULT.
11. Follow the instruction of CONSULT display.
    NOTE:

    It will take at most 10 minutes until "COMPLETED" is displayed.

12. Touch "SELF-DIAG RESULTS".

Which is displayed on CONSULT screen?

OK 

INSPECTION END

NG 

Proceed to DIAGNOSIS PROCEDURE .

CAN NOT BE DIAGNOSED 

GO TO STEP 4. 

1. Turn ignition switch OFF and leave the vehicle in a cool place (soak the vehicle).
2. Perform DTC confirmation procedure again.

GO TO STEP 3. 

Perform component function check. Refer to COMPONENT FUNCTION CHECK .

Is the inspection result normal?

YES 

INSPECTION END

NO 

Proceed to DIAGNOSIS PROCEDURE .