LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Engine Control System (DTC/Circuit Diagnosis) (VQ35DE) (Except Hybrid) (1 Of 3)) >> DTC/Circuit Diagnosis >> DTC P0037, P0038, P0057, P0058: Ho2S2 Heater >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. PRECONDITIONING

    If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    TESTING CONDITION: 

    Before performing the following procedure, confirm that battery voltage is between 10.5 V and 16 V at idle. 

    GO TO STEP 2. 

  2. PERFORM DTC CONFIRMATION PROCEDURE

    1. Start engine and warm it up to the normal operating temperature.
    2. Turn ignition switch OFF and wait at least 10 seconds.
    3. Turn ignition switch ON.
    4. Turn ignition switch OFF and wait at least 10 seconds.
    5. Start engine and keep the engine speed between 3, 500 and 4, 000 rpm for at least 1 minute under no load.
    6. Let engine idle for 1 minute.
    7. Check 1st trip DTC.

    Is 1st tip DTC detected?

    YES 

    Proceed to DIAGNOSIS PROCEDURE .

    NO 

    INSPECTION END

scientia non olet · About LEMON Manuals