LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Warning Chime System (Except Hybrid)) >> DTC/Circuit Diagnosis >> Seat Belt Buckle Switch Signal Circuit >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. CHECK SEAT BELT BUCKLE SWITCH

    1. Turn ignition switch OFF.
    2. Disconnect the seat belt buckle switch (driver seat) connector.
    3. Check continuity between the seat belt buckle switch (driver seat) terminals 3 and 4.
      3- 4  
      When seat belt is fastened : Continuity should not exist.
      When seat belt is unfastened : Continuity should exist.

    Is the inspection result normal?

    YES 

    Inspection End.

    NO 

    Replace the seat belt buckle switch (driver seat). Refer to REMOVAL AND INSTALLATION .

scientia non olet · About LEMON Manuals