LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Security Control System (DTC/Circuit Diagnosis) (Except Hybrid)) >> DTC/Circuit Diagnosis >> DTC B2604: Shift Position >> DTC Logic >> DTC Detection Logic

DTC Detection Logic

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • If DTC B2604 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to DTC LOGIC .
  • If DTC B2604 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to DTC LOGIC .
DTC No. Trouble diagnosis name DTC detecting condition Possible cause
B2604 PNP/CLUTCH SW The following states are detected for 5 seconds while ignition switch is ON:
  • P/N position signal is sent from TCM but shift position signal input (CAN) from TCM is other than P (Park) and N (Neutral)
  • P/N position signal is not sent from TCM but shift position signal input (CAN) from TCM is P (Park) or N (Neutral)
  • Harness or connectors

    (CAN communication line is open or shorted.)

  • Harness or connectors

    (TCM circuit is open or shorted.)

  • TCM
  • BCM
scientia non olet · About LEMON Manuals