Diagnosis Procedure

Regarding Wiring Diagram information, refer to WIRING DIAGRAM .

1. CHECK CVT SHIFT SELECTOR SWITCH FUNCTION
   
   
   1. Turn ignition switch ON.
   2. Select "DETE/CANCEL SW" and "DETENT SW - IPDM" in DATA MONITOR mode with CONSULT.
   3. Check "DETE/CANCEL SW" and "DETENT SW - IPDM" indication under the following conditions.

      Monitor item	Condition		Indication
      DETE/CANCEL SW	CVT Shift selector	In any position other than P (Park)	OFF
      		P (Park)	ON
      DETENT SW - IPDM	CVT Shift selector	In any position other than P (Park)	OFF
      		P (Park)	ON

   Is the inspection result normal?

   YES 

   Refer to INTERMITTENT INCIDENT .

   NO-1 

   If DETE/CANCEL SW function is incorrect. GO TO 2.

   NO-2 

   If DETENT SW - IPDM function is incorrect. GO TO 5.

2. CHECK CVT SHIFT SELECTOR CIRCUIT (BCM)
   
   
   1. Disconnect BCM connector and IPDM E/R connector.
   2. Check continuity between CVT shift selector (park position switch) harness connector and BCM harness connector.

      CVT shift selector (park position switch)		BCM		Continuity
      Connector	Terminal	Connector	Terminal
      M78	6	M18	20	Yes

   3. Check continuity between CVT shift selector (park position switch) harness connector and ground.

      CVT shift selector (park position switch)		Ground	Continuity
      Connector	Terminal
      M78	6		No

   Is the inspection result normal?

   YES 

   GO TO STEP 3  .

   NO 

   Repair or replace harness.

3. CONNECTOR INSPECTION
   
   
   1. Disconnect BCM.
   2. Check connectors and terminals for deformation, disconnection, looseness or damage.

   Is the inspection result normal?

   YES 

   GO TO STEP 4  .

   NO 

   Repair or replace as necessary.

4. REPLACE BCM
   
   
   1. Replace BCM. Refer to REMOVAL AND INSTALLATION .
   2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT.

   Inspection End.

5. CHECK CVT SHIFT SELECTOR CIRCUIT (IPDM E/R)
   
   

   Check continuity between CVT shift selector (park position switch) harness connector and IPDM E/R harness connector.

   CVT shift selector (park position switch)		IPDM E/R		Continuity
   Connector	Terminal	Connector	Terminal
   M78	6	E119	31	Yes

   Is the inspection result normal?

   YES 

   GO TO STEP 6  .

   NO 

   Repair or replace harness.

6. CONNECTOR INSPECTION
   
   
   1. Disconnect IPDM E/R.
   2. Check connectors and terminals for deformation, disconnection, looseness or damage.

   Is the inspection result normal?

   YES 

   GO TO STEP 7  .

   NO 

   Repair or replace as necessary.

7. REPLACE IPDM E/R
   
   
   1. Replace IPDM E/R. Refer to REMOVAL AND INSTALLATION .

   Inspection End.