LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Security Control System (DTC/Circuit Diagnosis) (Except Hybrid)) >> DTC/Circuit Diagnosis >> DTC B210E: Starter Relay >> DTC Logic >> DTC Detection Logic

DTC Detection Logic

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • If DTC B210E is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to DTC LOGIC .
  • If DTC B210E is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to DTC LOGIC .
  • When IPDM E/R power supply voltage is low (Approx. 7 - 8 V for about 1 second), the DTC B210F may be detected.
DTC No. Trouble diagnosis name DTC detecting condition Possible cause
B210E STARTER RELAY OFF When comparing the following items, IPDM E/R detects that starter control relay is stuck in the OFF position for 5 second or more:
  • Starter control relay signal (CAN) from BCM.
  • Starter relay status signal (CAN) from BCM.
  • Starter control relay and starter relay status signal (IPDM E/R input).
  • Starter control relay control signal (IPDM E/R output).
  • IPDM E/R
  • BCM
  • Battery
scientia non olet · About LEMON Manuals