System Control Condition Display

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

Push and hold the ICC MAIN switch for longer than approximately 1.5 seconds. This mode will be in a standby state for setting.

Condition			Display on ICC system display
Standby mode			Courtesy of NISSAN NORTH AMERICA, INC.
Control mode	Without a vehicle ahead	Set vehicle distance (Long)	Courtesy of NISSAN NORTH AMERICA, INC.
		Set vehicle distance (Middle)	Courtesy of NISSAN NORTH AMERICA, INC.
		Set vehicle distance (Short)	Courtesy of NISSAN NORTH AMERICA, INC.
		When the vehicle speed exceeds the set speed	Courtesy of NISSAN NORTH AMERICA, INC.
Control mode	With a vehicle ahead	Set vehicle distance (Long)	Courtesy of NISSAN NORTH AMERICA, INC.
		Set vehicle distance (Middle)	Courtesy of NISSAN NORTH AMERICA, INC.
		Set vehicle distance (Short)	Courtesy of NISSAN NORTH AMERICA, INC.
		When the vehicle speed exceeds the set speed	Courtesy of NISSAN NORTH AMERICA, INC.

NOTE:

The display of the DCA system is given priority when the DCA system is ON in a standby mode. (The set vehicle speed indicator and set distance indicator are not displayed).