Removal And Installation: Notes
WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Situate the vehicle on a flat and solid surface.
- Place chocks at front and back of rear wheels.
- For engines not equipped with engine slingers, attach proper slingers and bolts described in PARTS CATALOG.
CAUTION:
- Always work safely.
- Do not start work until the engine and exhaust system are cooled completely.
- Refer to the applicable information for warnings, cautions, notes, and instructions if necessary procedures are not included in the engine information.
- For supporting, lifting and jacking points, refer to 2-POLE LIFT and GARAGE JACK AND SAFETY STAND .
- Always use the support point specified for lifting.
- Support the vehicle at the rear axle jacking point with transmission jack or similar tool before removing the engine in preparation for the backward shift of the center of gravity.
NOTE:
When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.