LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Brake System (Except Hybrid)) >> Unit Disassembly And Assembly >> Rear Disc Brake >> Disassembly And Assembly >> Inspection After Installation

Inspection After Installation

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check the drag of rear disc brake. If any drag is found, follow the procedure described below.
  2. Remove brake pads.
  3. Using a suitable tool, press the pistons into the brake caliper body.
    CAUTION:

    Do not damage the piston boots.

  4. Install brake pads.
  5. Depress the brake pedal several times.
  6. Check the drag of rear disc brake again. If any drag is found, disassemble the brake caliper body.
  7. Burnish contact surfaces after refinishing or replacing disc rotors or if a soft pedal occurs at very low mileage. Refer to INSPECTION .
scientia non olet · About LEMON Manuals