LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Brake System (Except Hybrid)) >> Periodic Maintenance >> Rear Disc Brake >> Brake Pad >> Inspection And Adjustment >> Adjustment

Inspection And Adjustment: Adjustment

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Burnish contact surfaces between brake pads and disc rotor according to the following procedure after refinishing the disc rotor, replacing brake pads or if a soft pedal occurs at very low mileage.
  • Be careful of vehicle speed. Brakes do not operate firmly/securely until pads and disc rotor are securely seated.
  • Only perform this procedure under safe road and traffic conditions. Use extreme caution.
  1. Drive the vehicle on straight, flat road.
  2. Depress the brake pedal until the vehicle stops.
  3. Release the brake pedal for a few minutes to allow the brake components to cool.
  4. Repeat steps 1 to 3 until pad and disc rotor are securely seated.
scientia non olet · About LEMON Manuals