LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Tires, Wheels & Tire Pressure Monitoring System (TPMS) (Except Hybrid)) >> Basic Inspection >> Id Registration Procedure >> Work Procedure >> TPMS Registration With Consult Only >> With Consult

With Consult

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Adjust the tire pressure for all wheels to match the list below.
    Tire position Tire pressure kPa (kg/cm2 , psi)
    Front LH 240 (2.4, 35)
    Front RH 220 (2.2, 32)
    Rear RH 200 (2.0, 29)
    Rear LH 180 (1.8, 26)
  2. Turn the ignition switch ON.
  3. Using CONSULT, select "WORK SUPPORT" in BCM (AIR PRESSURE MONITOR). Then, select "ID REGIST."
  4. Select "Start" on "ID REGIST" screen.
  5. Drive the vehicle at a speed greater than 40 km/h (25 MPH) for 3 minutes or more.
  6. After ID registration for all wheels is complete, press "End" on the CONSULT to finish ID registration.
    ID registration position CONSULT
    Front LH "Yet (red)"
    ↓
    "Done (green)"
    Front RH
    Rear RH
    Rear LH
  7. Adjust the tire pressures for all tires to the recommended value. Refer to TIRE AIR PRESSURE .
  8. Test drive the vehicle to ensure that the TPMS lamp is OFF and no warning messages are present.
scientia non olet · About LEMON Manuals