How To Set
WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
With CONSULT
Perform the "CLEAN SW SET" of HVAC work support item.
| Work support items | Display | Setting |
|---|---|---|
| CLEAN SW SET | Mode1 | Initial setting |
| Mode2 | Setting 1 | |
| Mode3 | Setting 2 | |
| Mode4 | Setting 3 |
| Initial setting | When the auto intake switch is ON, the A/C switch is also turned ON in synchronization with the auto intake switch. Control of the auto intake switch is functional even when the A/C switch is turned OFF. |
|---|---|
| Setting 1 | When the auto intake switch is ON, the A/C switch is not turned ON in synchronization with the auto intake switch. Control of the auto intake switch is functional even when the A/C switch is turned OFF. |
| Setting 2 | When the auto intake switch is ON, the A/C switch is also turned ON in synchronization with the auto intake switch. When the A/C switch is turned OFF, the auto intake switch is turned OFF in synchronization with the A/C switch. |
| Setting 3 | Auto intake switch can be turned ON only when A/C switch is ON. When the A/C switch is turned OFF, the auto intake switch is turned OFF in synchronization with the A/C switch. |
NOTE:
When the battery cable is disconnected from the negative terminal or when the battery voltage becomes 10 V or less, the setting of WORK SUPPORT may be cancelled.