Diagnosis Procedure
WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
Regarding Wiring Diagram information, refer to WIRING DIAGRAM .
- CHECK INTAKE DOOR MOTOR COMMUNICATION SIGNAL
- Turn ignition switch ON.
- Check output waveform between intake door motor harness connector and ground with the oscilloscope.
+ - Output waveform Intake door motor Connector Terminal M128 2 Ground
Is the inspection result normal?
YES
GO TO STEP 2 .
NO
GO TO STEP 3 .
- CHECK INSTALLATION OF INTAKE DOOR MOTOR
Check intake door motor is properly installed. Refer to EXPLODED VIEW .
Is the inspection result normal?
YES
Replace intake door motor. Refer to REMOVAL AND INSTALLATION .
NO
Repair or replace malfunctioning part.
- CHECK INTAKE DOOR MOTOR COMMUNICATION SIGNAL CIRCUIT
- Turn ignition switch OFF.
- Disconnect intake door motor and A/C auto amp. connector.
- Check continuity between intake door motor harness connector and A/C auto amp. harness connector.
Intake door motor A/C auto amp. Continuity Connector Terminal Connector Terminal M128 2 M50 16 Yes
Is the inspection result normal?
YES
Replace A/C auto amp. Refer to REMOVAL AND INSTALLATION .
NO
Repair harness or connector.