LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Roof (Except Hybrid)) >> Removal And Installation >> MONROVIA Unit Assembly >> Inspection >> Link And Wire Assembly

Link And Wire Assembly

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Before replacing a suspect part, make sure it is the source of noise being experienced.

  1. Check link to determine if coating film has peeled off excessively enough that substrate is visible. Check also to determine if link is the source of noise. Replace as necessary.
  2. Visually check to determine if a sufficient amount of grease has been applied to wire or rail groove. If not, add grease as required.
  3. Check wire for any damage or deterioration. If any damage is found, replace Monrovia unit assembly. Refer to REMOVAL AND INSTALLATION 
scientia non olet · About LEMON Manuals