Surface Height Adjustment

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

Tilt glass lid up and down several times using Monrovia switch to check that it operates smoothly.
Check height difference between roof surface and glass lid surface, then compare to specifications.
If necessary, adjust height difference by using the following procedure.
- Loosen glass lid bolts.
- Manually raise/lower glass lid until height difference is within specification.
  NOTE:
  If necessary, shims may be added between Monrovia unit assembly and roof to increase adjustment range. Refer to REMOVAL AND INSTALLATION .
  
  Temporarily loosely tighten Monrovia unit assembly bolts to prevent movement between each adjustment.
- Tilt glass lid up and down several times using Monrovia switch to check that it operates smoothly.
- Tighten glass lid and Monrovia side bracket bolts.
  NOTE:
  First tighten left front bolt, then right rear bolt on glass lid to prevent uneven torque while tightening remaining bolts.
- After any adjustment, check Monrovia operation and glass lid alignment.