Diagnosis Procedure

Regarding Wiring Diagram information, refer to WIRING DIAGRAM .

1. CHECK SUNSHADE SWITCH INPUT SIGNAL
   
   
   1. Turn ignition switch ON.
   2. Check voltage between sunshade motor assembly harness connector and ground.

      (+)		(-)	Condition	Voltage (Approx.)
      Sunshade motor assembly
      Connector	Terminals
      B85	6	Ground	Sunshade switch is operated OPEN (1st)	0
      			Other than above	Battery voltage
      	2		Sunshade switch is operated CLOSE (2nd)	0
      			Other than above	Battery voltage

   Is the inspection result normal?

   YES 

   Inspection End.

   NO 

   GO TO STEP 2  .

2. CHECK SUNSHADE SWITCH CIRCUIT
   
   
   1. Turn ignition switch OFF.
   2. Disconnect sunshade motor assembly connector and sunshade switch connector.
   3. Check continuity between sunshade motor assembly harness connector and sunshade switch harness connector.

      Sunshade motor assembly		Sunshade switch		Continuity
      Connector	Terminal	Connector	Terminal
      B85	2	R110	3	Yes
      	6		1

   4. Check continuity between sunshade motor assembly harness connector and ground.

      Sunshade motor assembly		Ground	Continuity
      Connector	Terminal
      B85	2		No
      	6

   Is the inspection result normal?

   YES 

   GO TO STEP 3  .

   NO 

   Repair or the replace harness.

3. CHECK SUNSHADE SWITCH GROUND CIRCUIT
   
   

   Check continuity between sunshade switch harness connector and ground.

   Sunshade switch		Ground	Continuity
   Connector	Terminal
   R110	2		Yes

   Is the inspection result normal?

   YES 

   GO TO STEP 4  .

   NO 

   Repair or replace the harness.

4. CHECK SUNSHADE SWITCH
   
   

   Check sunshade switch.

   Refer to COMPONENT INSPECTION .

   Is the inspection result normal?

   YES 

   GO TO STEP 5  .

   NO 

   Replace sunshade switch. Refer to REMOVAL AND INSTALLATION .

5. CHECK INTERMITTENT INCIDENT
   
   

   Refer to INTERMITTENT INCIDENT .

   Inspection End.