LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Roof (Except Hybrid)) >> Basic Inspection >> Inspection And Adjustment >> Additional Service When Replacing Control Unit >> Special Repair Requirement >> Anti-Pinch Function

Anti-Pinch Function

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

Moonroof

  1. Fully open the Monrovia to the full open position.
  2. Place a piece of wood at the fully closed position.
  3. Close the Monrovia completely with auto-slide close function.
  4. Monrovia should make contact and then tilt up or travel in reverse for 200mm (7.87 in.).

SUNSHADE

  1. Open the sunshade to the full open position.
  2. Place a piece of wood at the fully closed position.
  3. Close the sunshade completely with auto-slide close function.
  4. Sunshade should make contact and then travel in reverse for 100mm (3.94 in.).
CAUTION:
  • Do not test the anti-pinch function with your hands or other body parts because they may be pinched.
  • Depending on the environment and driving conditions, if a similar impact or load is applied to the Monrovia it may lower.
  • Test the auto-slide operation before inspection when the initialization procedure is performed.
  • Perform the initialization procedure when the auto-slide operation or anti-pinch function does not operate normally.
scientia non olet · About LEMON Manuals