Hood Stay: Disposal

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

Fix hood stay (1) using a vise (C).

Courtesy of NISSAN NORTH AMERICA, INC.
Using a hacksaw (A) slowly make two holes in the hood stay (1), in numerical order as shown in the illustration.
CAUTION:
- When cutting a hole on hood stay (1), always cover hacksaw (A) with a shop cloth (B) to avoid scattering metal fragments or oil.
- Wear eye protection (safety glasses).
- Wear gloves.
A: 20 mm (0.79 in)

B: Cut at the groove.

Courtesy of NISSAN NORTH AMERICA, INC.

A:	20 mm (0.79 in)
B:	Cut at the groove.